MOLDED COMPRESSOR MOUNT

Compressor Mount Mid-States Rubber operates a large facility equipped with over 70 dedicated compression and transfer molding presses that enable us to achieve high volume manufacturing on tight delivery timelines. We produced the compressor mount shown here in large quantities for a customer in the appliance industry. Our engineers developed a compression and transfer molding process that would allow these small parts to be made very economically and with short cycle times. Tooling design allowed us to use multi-cavity molds to produce multiple components with each cycle, and cryogenic finishing enabled us to cleanly remove the flash while maintaining part integrity and critical tolerances.

Featuring 50 durometer Shore A EPDM rubber construction, we molded these components, which featured dimensions of 1.25” in width and 0.938” in height, to within RMA A3 tolerances for commercial products. Our integrated processes enabled us to achieve uniformity over the entire 750,000 unit production run, which we accomplished on 4 week timetable.

To learn more about this project or how our comprehensive rubber molding services can benefit your next project, contact us today.

Request a Quote

COMPRESSOR MOUNT SPECIFICATIONS

Product Description

Compressor Mount

Capabilities Applied/Processes

Design Consultation, Compression and Transer Molding

Tolerance

RMA A3

Material

50 Durometer Shore A EPDM Rubber Polymer

Product Dimensions

1.25 inches wide, .938 high

Secondary Operations Applied

Cyrogenic Finishing

Industry for Use

Appliance

Volume

750,000

Delivery Time

2 to 4 weeks

Delivery Location

International

Standards Met

RMA A3, Customer Spec

Design Work

Built to Customer Spec

Drawing Type Accepted

Drawing / Blueprint