Molded Rubber Products
Serving the World Since 1944

Molded Compressor Mount

Compressor Mount
Compressor Mount

Mid-States Rubber operates a large facility equipped with over 70 dedicated compression and transfer molding presses that enable us to achieve high volume manufacturing on tight delivery timelines. We produced the compressor mount shown here in large quantities for a customer in the appliance industry. Our engineers developed a compression and transfer molding process that would allow these small parts to be made very economically and with short cycle times. Tooling design allowed us to use multi-cavity molds to produce multiple components with each cycle, and cryogenic finishing enabled us to cleanly remove the flash while maintaining part integrity and critical tolerances.

Featuring 50 durometer Shore A EPDM rubber construction, we molded these components, which featured dimensions of 1.25” in width and 0.938” in height, to within RMA A3 tolerances for commercial products. Our integrated processes enabled us to achieve uniformity over the entire 750,000 unit production run, which we accomplished on 4 week timetable.

To learn more about this project or how our comprehensive rubber molding services can benefit your next project, contact us today.

Compressor Mount Specifications

Product Description
Compressor Mount
Capabilities Applied/Processes
Design Consultation, Compression and Transer Molding
Tolerance
RMA A3
Material
50 Durometer Shore A EPDM Rubber Polymer
Product Dimensions
1.25 inches wide, .938 high
Secondary Operations Applied
Cyrogenic Finishing
Industry for Use
Appliance
Volume
750,000
Delivery Time
2 to 4 weeks
Delivery Location
International
Standards Met
RMA A3, Customer Spec
Design Work
Built to Customer Spec
Drawing Type Accepted
Drawing / Blueprint
Printable PagePrintable Page Email This PageEmail This Page
Copyright © 2014 Mid-States Rubber Products, Inc., All Rights Reserved. Site created by Thomas Web Solutions